Package list:

1* inpower cable

1 *usb contact cable

1*software cd, software will be actived by our engineer.

InPower provides the following functions for monitored equipment:

• Direct connection capability from a personal computer to PowerCommand genset controls, transfer controls, and system controls; For details on devices supported refer Technical Details tab.

• Connection to generator set or transfer switch controls via modem or to multiple controls via PowerCommand (LonWorks) network.

• Allows the monitored equipment to send alarm information to a connected computer.

• Configurable for units of measurement, and level of user access (read only, read/change values, administrator).

• Adjustment of nearly every adjustment parameter within the connected control system, including parameters such as voltage and frequency levels, gains, protection set-points and other values.

• Convenient programming of configurable inputs in the controllers.

• Viewing of equipment history, fault codes, and data associated with fault codes.

• Generates reports of monitored data

• Allows released firmware upgrades on Power Command genset controls.

• Plot critical parameters in a strip chart format, and export data to 3rd party software tools for manipulation and viewing.

• Simulate fault conditions in genset controls in compliance to NFPA 110 requirements to demonstrate functionality of the controller and monitoring equipment in a facility.